What is a brick lining wall?

A brick lining wall is a thin wall built in front of an existing wall, with the bricks laid on their narrow side — as stretchers or headers. The Dutch term is klampmuur. What separates it from a klamplaag, a brick-on-edge facing course, is the position: the facing course lies against the existing wall, while […]

What is a brick-on-edge facing course?

A brick-on-edge facing course is a layer of bricks laid on their broad, flat side directly against an existing wall. It is placed dry (without adhesive) or in ordinary mortar against the existing wall face. In English it is also called a shiner course: the large flat face of the brick shows. The Dutch term […]

What is a cleat?

A cleat is usually a timber block, batten, small board or piece of sheet material used to join parts of a construction, to support them, to clamp them or to stop them shifting. The Dutch word klamp comes from klemmen, to clamp or grip. Besides timber, cleats are also made in stainless steel, iron, lead […]

What is sealant?

Sealant is the general name for paste-like sealing and jointing compounds gunned from a cartridge to close joints and gaps against draughts and moisture. Once cured it stays flexible, so it can follow the movement between two elements without splitting. It is applied with a sealant gun; cartridges are typically around 290 ml. Worth being […]

What is a rubble-cored wall?

A rubble-cored wall is a heavy wall construction with a built inner and outer leaf whose very thick cavity is filled with sand, stone and rubble. The two leaves form, in effect, the sides of a box; the fill supplies mass and with it stability. The Dutch term is kistwerk, literally “box work”. It is […]

What is lateral torsional buckling?

Lateral torsional buckling is the deflection of a loaded member in its so-called weak direction, perpendicular to the plane of bending, combined with a twist of the cross section. The beam does not simply sag downwards as intended: it also moves sideways and rotates about its own length. The Dutch term for it is kip. […]

What is a common joist?

A common joist is a relatively light floor joist that runs across, or partly into, the heavier main beams, spanning from beam to beam or from beam to wall. Together they form the traditional main beam and joist floor found in almost every historic Dutch building; the Dutch terms are moerbalk (main beam) and kinderbalk […]

What is an upstand reinforcing strip?

On bituminous flat roofing, an upstand reinforcing strip is an extra strip of membrane in the corner where the roof surface turns up against a rising element — a roof edge, a wall or a parapet. The strip runs about 15 cm out onto the roof surface and is then taken up the upstand, so […]

What is a wall-floor joint?

A wall-floor joint is the junction between the floor and the rising wall — in effect the joint where those two elements meet. It is one of the most common leak points in a building, because two elements never meet completely seamlessly and small voids always remain. Where water stands under pressure on one side, […]

What is a levelling course?

A levelling course is the first course of bricks or blocks in a wall, bedded dead level in mortar on the foundation right around the building. In Dutch it is called the kimlaag, from kim, the line where wall and floor meet — a word that originally meant edge. The course has one main job: […]