What is land reclamation?

Land reclamation is the process of making uncultivated, waste or waterlogged ground fit for agriculture or building. Depending on the starting point that means clearing woodland, draining wet ground by embanking and pumping, or improving poor sandy soils. The field pattern created by a reclamation is often still legible in the landscape and on the […]

What is unreinforced concrete?

Unreinforced concrete — also called plain concrete — is concrete with no reinforcement, or with a negligible amount, that is structurally loaded in compression only. Concrete is strong in compression but weak in tension: its tensile strength is only a fraction of its compressive strength. As soon as tensile stresses arise, unreinforced concrete cracks. Its […]

What is undisturbed soil?

Undisturbed soil is ground that has not been excavated, disturbed or filled, and therefore retains its natural layering and density. The opposite is disturbed soil or made ground: earth that has been dug out and replaced, or built up with imported sand or rubble. Why the distinction matters Soil owes its bearing capacity to the […]

What is quicklime?

Quicklime is burnt lime — calcium oxide (CaO) — that has not yet been mixed with water. It is the intermediate product in the lime cycle: limestone is burnt to quicklime, and quicklime is then slaked with water to produce slaked lime (calcium hydroxide), the binder for lime mortar and limewash. It is also called […]

What is a ridge roll?

A ridge roll is a flexible, wide strip fitted beneath the ridge tiles that closes the opening between the tiling and the ridge batten. The strip is perforated or made of an air-permeable material, so the ridge still works as a ventilation opening. Together with ridge clamps it forms what is known as a dry […]

What is a vertical roof outlet?

A vertical roof outlet — also called a bottom outlet — is a rainwater outlet that takes water straight down through the roof deck. Immediately below the roof it connects to a vertical downpipe, sometimes via a short swept bend. It is the most common solution on flat roofs of sheds, garages, extensions and larger […]

What is propping?

Propping is the temporary support of a building element with adjustable props, so that the element does not fail or deflect before it can carry its own load. A prop is a height-adjustable steel tube with a base plate and a head plate; in the UK it is often called an acrow prop or a […]

What is a girder?

A girder is a heavy beam that runs beneath the floor joists and supports them. Because the joists gain an intermediate bearing, their span is halved and deflection drops dramatically. Today a girder is usually a steel I-section or H-section; in older buildings it is often a substantial timber beam. The Dutch term is onderslagbalk. […]

What is base plate grouting?

Base plate grouting is completely filling the gap between two structural elements — usually beneath the base plate of a steel column or a machine — with a purpose-made pourable grout. The point is that the load is transferred evenly across the whole bearing area, rather than through a few small packing shims. The Dutch […]

What is a roof soffit?

A roof soffit is the underside of a projecting roof: the surface you see when you look up at the eaves overhang and the gutter from below. The Dutch language preserves an old, regional word for it — onderplezier — but in modern practice it is simply the soffit, the eaves lining or the overhang […]