A nonius hanger is a two-part suspension component that lets you hang a suspended ceiling at almost any height below the floor or roof above. It consists of an upper part fixed to the structure, a lower part that clips onto the ceiling channel, and a nonius clip (a sprung pin) that locks the two together at the chosen height.

Why use one?

The simple direct hanger — a perforated strap — only works for small drops of a few centimetres. As soon as you need more space for ducts, services or a large step in ceiling level, it runs out. The nonius hanger bridges large drops and stays adjustable while you set it.

Components

Part Function
Upper part Vertical strap fixed to the concrete soffit, timber joist or steel beam
Lower part Bracket that clips onto the ceiling channel (usually CD 60/27)
Nonius clip Sprung pin that locks upper and lower parts after adjustment
Extension Optional extra upper part for very large drops

Installation steps

  1. Fix the upper parts — set out the grid according to the manufacturer’s system data and fix the upper parts to the structure
  2. Clip on the lower parts — fit them onto the CD channels
  3. Slide and align — slide the lower part over the upper part to the required ceiling height; check with a laser or water level
  4. Lock — drive in the nonius clip so the joint cannot slip
  5. Trim — cut off the projecting length of the upper part

Points to watch

Related terms

Want to learn more about construction terms? Visit our knowledge base at fredsdiyplans.com.

Leave a Reply

Your email address will not be published. Required fields are marked *