A hardwood deck is an investment of EUR 1,500 to 5,000 for an average garden. Without proper maintenance, the wood turns grey, green algae builds up and the surface becomes dangerously slippery. After a few years of neglect, you’re left with a deck that looks bad and is potentially hazardous. The good news: with just a few hours of maintenance twice a year, your deck will last 15 to 25 years instead of 8 to 10 years. The material costs for a complete maintenance session are between EUR 40 and 100. That’s a fraction of the replacement cost. In this article, you’ll learn exactly how to clean your deck, safely remove green algae and protect the wood with the right oil or stain. Complete with a practical seasonal schedule so you know exactly when to do what.

Why deck maintenance matters

A wooden deck is exposed to rain, sun, frost and moisture all year round. Without protection, several things happen:

Green algae. Algae and moss grow on damp wood, especially on the shady side. This makes your deck dangerously slippery and is a fall hazard.

Greying. UV radiation breaks down the lignin in the wood. The result: that beautiful warm brown turns into a dull grey.

Cracking and splintering. Wood that dries out in the sun shrinks and cracks. Without oil, the wood loses its elasticity.

Mould and wood rot. Moisture that penetrates the wood over time causes mould growth and eventually wood rot, particularly on the underside of the boards.

Insect damage. Unprotected wood attracts wood-boring beetles and other insects.

Lifespan by wood type

Wood type Lifespan without maintenance Lifespan with maintenance Maintenance level
Bangkirai 10 – 15 years 20 – 25 years Medium
Ipe (ironwood) 15 – 25 years 25 – 40 years Low
Douglas fir 8 – 12 years 15 – 20 years High
Thermowood (thermally modified) 10 – 15 years 20 – 25 years Medium
Pine (pressure treated) 8 – 10 years 12 – 18 years High
Composite 15 – 25 years 20 – 30 years Low

The right timing: seasonal schedule for deck maintenance

Timing matters. Oiling your deck in the middle of winter is pointless, and removing green algae in full sun isn’t ideal either.

Annual deck maintenance schedule

Period Action Why then?
March – April Major clean + green algae removal Most buildup occurs over winter
May – June Oiling or staining Dry weather, wood is clean and dry after spring cleaning
August – September Light cleaning + inspection Mid-season check
October – November Second oil/stain treatment (optional) Extra protection layer before winter
December – February Do nothing Too cold and wet for maintenance

Ideal conditions for oiling: dry weather (at least 2 rain-free days expected), temperature between 10 and 25 degrees Celsius, not in direct sunlight.

Step 1: Remove loose dirt

Always start with the rough work.

  1. Remove all furniture, pots and decorations from the deck
  2. Sweep away leaves, twigs, sand and other loose dirt with a stiff broom
  3. Clean the gaps between boards with a narrow spatula or old screwdriver
  4. Remove any weeds growing between the boards
  5. Rinse the deck with a garden hose (low pressure)

Check the underside. If your deck is accessible from below, check for buildup of leaves and dirt. This traps moisture and accelerates wood rot.

Step 2: Remove green algae

Green algae is the most common enemy of your deck. There are several methods, each with pros and cons.

Methods compared

Method Cost Effectiveness Risk of damage Environmental impact
Green soap + brush EUR 5 – 10 Good for light buildup None None
Soda + water EUR 3 – 5 Good for light to moderate buildup Minimal None
Specialist wood cleaner EUR 10 – 25 Very good Minimal with correct use Low
Green algae remover EUR 7 – 13 per litre Very good Minimal Medium
Pressure washer EUR 0 (if you already have one) Quick results High None
Chlorine/bleach EUR 3 – 5 Effective High (discolouration) High

Recommended method: natural soap + brush

This is the safest and most effective method for most situations:

  1. Mix 50 ml green soap or linseed oil soap per 5 litres of warm water in a bucket
  2. Pour the soapy water over a section of the deck
  3. Let it soak for 10-15 minutes
  4. Scrub with a stiff brush or scrubber in the direction of the wood grain
  5. Rinse with clean water from the garden hose
  6. Work section by section so the soapy water doesn’t dry out

For stubborn green algae: specialist cleaner

For green algae that won’t come off with soap:

  1. Choose a specialist wood cleaner or green algae remover (concentrate costs approximately EUR 7-10 per litre and is sufficient for 100-200 m2 on smooth surfaces)
  2. Dilute the product according to the instructions on the packaging
  3. Apply with a plant sprayer or watering can
  4. Let the product do its work (often 24-36 hours)
  5. Scrub afterwards with a brush and rinse off

Why NOT to use the pressure washer

The pressure washer is tempting. Quick results, everything clean in one go. But it damages your deck:

If you still want to use a pressure washer: set the pressure low (maximum 80 bar), keep at least 30 cm distance, use a flat spray (not a point jet) and always work in the direction of the grain.

Step 3: Let the deck dry

After cleaning, the wood must dry completely before you apply oil or stain. This is a step that’s often skipped, with poor results as a consequence.

Step 4: Oiling or staining

This is where you protect the wood against the elements. There are two main options: oil and stain. Both have their own application.

Oil vs. stain compared

Property Hardwood oil Stain (opaque/transparent)
How it works Penetrates the wood, protects from within Forms a layer on the wood
Appearance Natural, enhances the wood colour Can add colour or cover completely
Maintenance Refresh 2-3 times per year Once every 2-3 years
Preparation Clean and dry wood Often requires sanding
Suitable for Hardwood (bangkirai, ipe) Softwood (pine, Douglas fir)
Peeling risk None (penetrates) Yes, with poor adhesion
Price EUR 15 – 35 per litre EUR 20 – 45 per litre

Rule of thumb: Use oil for hardwood, stain for softwood. Hardwood has a dense structure that stain adheres to poorly. Oil does penetrate and protects the wood from within.

Popular products compared

Product Type Volume Price (approx.) Coverage Suitable for
Osmo Terrace Oil Oil 2.5 litres EUR 50 – 65 12-16 m2 per litre All wood types
Remmers Care Oil Oil 2.5 litres EUR 35 – 50 8-12 m2 per litre All wood types
Xyladecor Terrace Oil Oil 2.5 litres EUR 35 – 50 10-14 m2 per litre All wood types
Bondex Bangkirai Oil Oil 2.5 litres EUR 30 – 45 8-12 m2 per litre Bangkirai
Ronseal Decking Oil Oil 2.5 litres EUR 25 – 40 8-12 m2 per litre All wood types
Sadolin Decking Stain Stain 2.5 litres EUR 35 – 50 8-10 m2 per litre Softwood

How to apply oil

  1. Stir the oil thoroughly (don’t shake it, that creates air bubbles)
  2. Apply a thin, even layer with a wide brush, roller or oil pad
  3. Work in the direction of the wood grain
  4. Work board by board, not across multiple boards at once
  5. Let the first coat soak in for 15-30 minutes
  6. Remove excess oil that hasn’t been absorbed with a clean cloth
  7. Let it dry for 12-24 hours
  8. Apply a second coat in the same way
  9. Allow at least 24 hours of drying time before using the deck again

How much oil do you need?

Deck surface Oil needed (2 coats) Estimated cost
Small (10 m2) 2 – 2.5 litres EUR 25 – 45
Medium (20 m2) 4 – 5 litres EUR 50 – 90
Large (30 m2) 6 – 7.5 litres EUR 75 – 135
Extra large (40+ m2) 8 – 10 litres EUR 100 – 180

Step 5: Mid-season check and minor maintenance

Halfway through the season (August/September), it’s wise to do a quick check:

Step 6: Winterising

Before autumn and winter:

  1. Give the deck a thorough sweep
  2. Remove all leaves from the gaps (leaves trap moisture)
  3. Optional: apply an extra coat of oil for additional protection
  4. Place furniture on rubber or felt pads to prevent stains
  5. Check that the drainage underneath the deck is clear

Special situations

Cleaning a composite deck

Composite requires less maintenance than wood, but it’s not maintenance-free.

Aspect Composite Wood
Green algae Occurs but more slowly Occurs quickly
Oiling needed No, never Yes, 2-3 times per year
Cleaning Warm water + soft brush Soap + stiff brush
Pressure washer No, damages the surface No, damages the surface
Stains Harder to remove Can be sanded out

Removing stubborn stains

Stain Solution
Bird droppings Remove immediately with warm water and soap
Rust (from furniture legs) Oxalic acid or specialist rust remover
Grease/oil (from barbecue) Soda + warm water, let soak, scrub
Red wine Soda + water, treat immediately
Tree sap Turpentine on a cloth, dab carefully
Mould stains Specialist wood brightener or lightly diluted bleach

Cost overview: complete seasonal maintenance

What does it cost to properly maintain your deck for a whole season? Here’s an overview for an average deck of 20 m2:

Item Product/action Cost
Green soap or linseed oil soap 1 litre EUR 5 – 10
Green algae remover (optional) Concentrate, 1 litre EUR 7 – 13
Hardwood oil (2 coats, 2x per year) 2x 2.5 litres EUR 60 – 100
Sandpaper (120 grit) 3-5 sheets EUR 5 – 8
Brush or roller 1 piece EUR 5 – 12
Stiff brush or scrubber 1 piece (lasts years) EUR 10 – 20
Total per season EUR 92 – 163

Compare that with the cost of a new deck (EUR 1,500 to 5,000 for materials plus installation) and it’s clear: maintenance is always cheaper than replacement.

Common mistakes

  1. Using the pressure washer at full power. The fastest way to ruin your deck. High pressure tears loose wood fibres, roughens the surface and actually causes green algae to return faster. Always use a brush and soap, or set the pressure washer to a maximum of 80 bar.

  2. Oiling on a damp or dirty surface. Oil on damp wood doesn’t adhere properly and can develop mould. Oil on a dirty deck seals in the dirt. Let the deck dry for at least 2-3 days after cleaning and do the water droplet test.

  3. Applying too much oil. More oil is not better. Too much oil doesn’t dry, becomes sticky and actually attracts dirt. Apply thin coats and remove excess oil after 15-30 minutes with a cloth.

  4. Postponing maintenance until it’s too late. Once the wood is deeply greyed or has wood rot, oil won’t help anymore. Then you’ll need to sand down to fresh wood or replace boards. Regular maintenance is cheaper than repairs.

  5. Using chlorine or bleach against green algae. Chlorine does remove green algae, but it also attacks the wood. The wood discolours, dries out and the protective wood extracts are broken down. Use biodegradable cleaning products.

  6. Oiling in direct sunlight. In the sun, the oil dries too quickly on the surface, preventing it from properly penetrating the wood. Oil in overcast weather or in the shade, at temperatures between 10 and 25 degrees Celsius.

Frequently asked questions

How often should I oil my deck?
For hardwood (bangkirai, ipe), 2 to 3 times per year is ideal: once in spring after cleaning, and optionally once in autumn before winter. With heavy use or strong sun exposure, an additional mid-season treatment may be worthwhile. A simple test: if water no longer beads up on the wood but soaks straight in, it’s time for a new coat of oil.

Can I prevent green algae?
Complete prevention isn’t possible if your deck is in a damp or shady environment. However, you can slow it down by regularly oiling the deck (this makes the surface less porous), promptly removing leaves and dirt, and ensuring good ventilation underneath the deck.

My deck has gone completely grey. Can it still be restored?
Yes, with a wood brightener you can largely restore the original colour. After brightening, lightly sand the surface and apply oil. For deeply greyed wood, it may be necessary to sand the deck lightly with an orbital sander. Then oil for an almost-new result.

Do I need to oil a composite deck?
No, composite never needs oiling. Composite is a mix of wood and plastic that doesn’t need protection against moisture or UV. Clean with warm water and a soft brush. Avoid abrasive cleaners and pressure washers.

Which oil is best for bangkirai?
Specially developed bangkirai oil gives the best results, as it is formulated for the dense structure and colour of bangkirai wood. Good options include Bondex Bangkirai Oil, Remmers Care Oil or Osmo Terrace Oil. Choose colourless if you want to maintain the natural wood colour, or a tinted version if you want a specific shade.

How do I remove mould from my deck?
Mould on a deck can be recognised by dark or black spots, sometimes with a musty smell. Remove mould with a specialist wood mould remover or a diluted oxalic acid solution. Let the product soak in, scrub with a brush and rinse off. After drying, apply oil. For recurring mould: check the ventilation underneath the deck.


DIY Plans and Guides

Want to get started with professional DIY plans and step-by-step guides? Check out the complete plans package at fredsdiyplans.com – with thousands of plans for every DIY project.


👉 View all DIY plans

Leave a Reply

Your email address will not be published. Required fields are marked *