What is an angled roof tile?
An angled roof tile — Dutch knikpan — is a roof tile with a bend in its profile, used to cover a change of pitch in the roof plane without a separate flashing or gutter detail. The tile is cranked along its length, so the upper part sits on one plane and the lower part […]
What is buckling?
Buckling is the sideways deflection of a column or strut under a compressive load. The member does not fail because the material is crushed, but because at a certain load it suddenly deflects to the side. From that point the deformation grows rapidly and collapse follows. Buckling is therefore a stability problem, not a strength […]
What is a haunched portal frame?
A haunched portal frame — Dutch kniespant — is a frame in which the vertical column and the sloping rafter form one continuous member, joined at an angled, rigid connection known as the knee or haunch. Because that connection carries moment, the frame is stable in its own plane without extra bracing in the roof […]
What is a compression strip?
A compression strip is a profile, usually aluminium or impact-resistant PVC, that mechanically clamps a roof membrane or a lead flashing against the wall. It fixes the turned-up edge of bitumen or EPDM at the top of the upstand and, together with a sealant, forms a junction that water cannot get behind. Two versions are […]
What is a thatch clamping board?
A thatch clamping board — Dutch knelplank — is the member at the eaves of a thatched roof against which the bottom course of reed is clamped. It does two jobs: it stops the wind getting under the thatch and lifting the lowest course, and it makes water run off the reed and drip clear […]
What is a compression fitting?
A compression fitting is a demountable pipe joint made up of three parts: the fitting body, a nut and a compression ring, usually called an olive. Tightening the nut deforms the brass or copper olive and wedges it between pipe and body. That deformed ring makes the joint watertight and gastight without soldering, pressing or […]
What is a twisted cluster column?
A twisted cluster column — Dutch kluwenzuil — is a column that looks as though it is made up of two or more columns wound around one another. The shaft reads as several strands twisted together like a rope, usually over the full height between base and capital. It is nearly always an illusion: the […]
What is a bracket block?
A bracket block — Dutch klos — is a block of timber, or sometimes masonry or stone, projecting from a wall or a beam to support a projecting element such as a gutter, an eaves overhang or a cornice. It is the simplest form of a console: a bearing point that carries the load of […]
What is a cloister rebate?
A cloister rebate — Dutch kloostersponning — is a rebate with a wide, usually U-shaped recess, for example in the underside of a floorboard or on the wall face of a window frame jamb. It is not a narrow rectangular rebate that something fits into, but a machined groove that removes part of the timber […]
What is a cloister window?
A cloister window — Dutch kloostervenster or kloosterkozijn — is a window type with two roughly equal openings stacked one above the other within a single frame: the upper opening was glazed, the lower one originally closed with a timber shutter. A horizontal transom (Dutch kalf) separates the two. The layout is purely practical. The […]
