What is a contraction joint?

A contraction joint is a partial cut into a building element that allows shrinkage and expansion to take place. By weakening the section locally, you force the material to crack exactly there — neatly under the saw cut, where nobody sees it — instead of somewhere random in the slab. So the joint itself does […]

What are crimping pliers?

The name crimping pliers is used for two different tools. What they have in common: both make something smaller by squeezing it. 1. Crimping pliers for pipes and ducts These cut a series of slits in the end of an aluminium or sheet metal pipe and then swage that end in, so it takes on […]

What is a shrinkage crack?

A shrinkage crack forms when a material wants to shrink but is restrained from doing so. The shrinkage builds up tensile stress; as soon as that exceeds the tensile strength, the material cracks. You see shrinkage cracks in concrete, screeds, plaster, masonry and timber. How to recognise one A shrinkage crack has several typical features: […]

What is shrinkage mesh?

Shrinkage mesh — also called crack-control mesh — is a cross-woven or welded steel wire mesh laid into a screed to limit cracking caused by shrinkage stress. It looks like reinforcing mesh but is noticeably lighter: it is not there to carry the floor, but to distribute the shrinkage. What it does — and does […]

What is shrinkage?

Shrinkage is the dimensional change in which a building material gets smaller, usually because it loses water. Almost every wet-applied or hygroscopic material shrinks: concrete, mortar, plaster, screeds, timber, and to a lesser extent plastics as they cool. As long as a material can shrink freely, little happens. The problem arises when shrinkage is restrained […]

What is an ashlar piece?

An ashlar piece is a short vertical post in a roof structure that stands on the ceiling or floor joist and is tenoned at its head into the rafter or roof beam. In Dutch roof carpentry the member is called a kreupele stijl and belongs above all to the improved Dutch truss. Why it is […]

What is a mending plate?

A mending plate is a metal plate fitted over or between two pieces of timber. It is used to stop splitting, to tie two members together, or both at once. In Dutch it is called a kramplaat. Three uses Against splitting. A plate on the end grain of a log, post or beam holds the […]

What is scraped render?

Scraped render is a thick, mineral, water-repellent render whose top layer is partly scraped away once it has set. That leaves a rough, evenly textured surface in which the aggregate — the grains — is exposed. The texture is granular and looks like a coarse decorative render. Where it is used Scraped render can be […]

What is beaded matchboarding?

Beaded matchboarding is boarding with a groove worked along one edge, so that a half-round profile — the bead — appears along the joint. The boards are jointed with tongue and groove; on the face it looks as though a fine round moulding separates each board from the next. In Dutch this material is called […]

What is a roll moulding?

A roll moulding is a simple round enrichment — a half-round or three-quarter-round bar — running around an opening or along an arris. It appears around portals, windows and niches, on wall corners and as the profile of a pilaster. In Dutch it is called a kraalprofiel, in English also a bowtell or bowtell moulding. […]