On 29 May 2026, the energy label for homes and buildings changes significantly across Europe. The EU’s EPBD IV directive (Energy Performance of Buildings Directive) is being transposed into national legislation across member states. The result: new indicators on the label, stricter calculation methods, and — for the first time — a mandatory energy label for listed and heritage buildings.
If you are planning to sell or rent out a property in the near future, this affects you. In this article, I explain exactly what is changing, who it applies to, and what you can do now.
What changes on 29 May 2026?
The entire framework for assessing the energy performance of buildings is being updated. This covers the calculation method, assessment guidelines, inspection protocols and associated software — all aligned with the EPBD IV requirements.
The three biggest changes:
1. New indicators on the energy label
The label will no longer show just a letter rating (A to G). It will also display:
- Annual final energy consumption — how much energy (kWh/m²) the property actually uses
- Operational greenhouse gas emissions — the CO₂ output associated with the building’s energy use
- QR code — linking to available grants and subsidies for energy improvements
- Detailed insulation scores — broken down by building element (roof, facade, floor, windows)
2. Home batteries and energy storage count towards the rating
For the first time, on-site energy storage will be factored into the calculation. EPBD IV requires that the positive impact of electricity and heat storage is included. Until 2030, this will be handled pragmatically, as storage does not yet fit perfectly within the existing primary fossil energy indicator.
Requirements for a home battery to qualify:
– Minimum 5 kWh storage capacity
– Connected to solar panels
– Complies with applicable electrical safety standards (e.g. NEN 1010 in the Netherlands)
3. Listed and heritage buildings now require an energy label
Until now, listed buildings were exempt from the energy label requirement in many countries. That changes on 29 May 2026. When selling or renting out a listed property, an energy label will be mandatory.
Sources: Gebouwenergieprestatie.nl, NIBAG
New label class: ZEB (A0)
A new top class is being introduced: ZEB — Zero Emission Building, also designated as A0. New-build properties will eventually be required to meet this standard. For existing buildings, it serves as a benchmark rather than an obligation.
| Label Class | What it means |
|---|---|
| ZEB / A0 | Zero emission building (new class) |
| A++++ | Highest existing class |
| A – G | Current scale, with stricter criteria |
What changes in the calculation method?
The underlying calculation method is being updated as part of the EPBD IV rollout. The key changes from 29 May 2026:
| Element | What changes |
|---|---|
| Energy storage | Home batteries and heat storage are included |
| Building automation (BACS) | Smart energy controls are weighted positively |
| CO₂ indicator | New: operational greenhouse gas emissions shown on the label |
| Final energy consumption | New: kWh/m² per year visible on the label |
Source: Gebouwenergieprestatie.nl
What does this mean for you as a homeowner?
You are planning to sell or rent out your property
You will need a valid energy label. Labels issued before 29 May 2026 remain valid — you do not need to have a new assessment done. But if you apply for a new label after 29 May, it will be assessed under the new method. That could mean your property receives a different rating than you might expect.
You own a listed or heritage building
For the first time, you will need a registered energy label when selling or renting out. No label means you risk a fine.
You have a home battery
Good news: from 29 May onwards, your battery counts towards your energy label. Depending on capacity and your solar setup, this can improve your label by half a grade to a full grade.
You are considering energy improvements
The new label shows, by building element, where the weakest points are (roof, facade, floor, windows). This makes it easier to prioritise targeted improvements.
Timeline
| Date | What happens |
|---|---|
| 15 November 2025 | Final versions of calculation methods and guidelines published |
| 1 January – 28 May 2026 | Mandatory retraining period for energy performance assessors |
| 29 May 2026 | New method comes into force |
| After 29 May 2026 | All new label assessments use the new method |
Source: IPLO EPBD IV Timeline
Frequently asked questions
Do I need to get a new energy label done?
No. Existing labels remain valid. Only new labels issued after 29 May 2026 will be assessed under the new method.
Could my property get a worse rating?
Yes. The criteria are being tightened. A property currently rated B could come out lower under a new assessment. The bar has simply been raised.
What does a new energy label cost?
Costs vary by country and property type. In the Netherlands, a typical assessment costs between €100 and €400, depending on the size and type of property. An accredited assessor visits in person. Expect similar ranges elsewhere in Europe.
Does this apply to rental properties too?
Yes. A valid energy label is required for new rental agreements. Properties without a label risk a fine.
Want to learn more about energy saving and sustainability? Visit fredsdiyplans.com.
